Image IMTL59105.1 User Manual download pdf (Page 9)

10.

Attach the Latch Housing (73) to the Left Upright (13)

with two Screws (3); start both Screws and then

tighten them. Make sure that the large hole in the

Latch Housing is on the indicated side.

Remove the knob from the pin. Make sure that the collar

and the spring are on the pin. (Note: If there are two col-

lars, place one on each side of the spring.) Next, insert

the pin into the Latch Housing (73). Then, tighten the

knob back onto the pin.

Before operating the treadmill, plug in the power

cord (see page 11), and then lower the treadmill to

the lowest incline level (see page 13).

Spring

Collar

Knob

11. Make sure that all parts are properly tightened before you use the treadmill. If there are sheets of clear

plastic on the treadmill decals, remove the plastic. To protect the floor or carpet, place a mat under the tread-

mill. Note: Extra hardware may be included. Keep the included allen wrench in a secure place; the large allen

wrench is used to adjust the walking belt (see page 23).

Large

Hole

9. Lower the Uprights (13, 14) until the Handrail (20) is

touching the floor.

See the lower drawing. Position the Uprights (13, 14) so

the Frame (58) is centered between them.

See the upper drawing. Firmly tighten the four Upright

Bolts (65). Then, raise the Uprights (13, 14) back to the

vertical position.

13, 14

Top View

. Hand tighten four additional Screws (3) into the Handrail

(20) and the console assembly. Then,

tighten all nine

crews used in step 7 and this step; do not over-

tighten the Screws.

Console Assembly

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 29 30

No comments

Image IMTL59105.1 User Manual Page 9